How Does Travel Adjust work?

Our travel adjust system allows for a total of 30mm travel reduction in 5mm increments. If you were riding that line between travel sizes you can now fine-tune the perfect fit by following the easy directions below:

  1. Begin by lowering your dropper at or below the desired travel length (just make sure it’s not fully extended!)
  2. Unthread the midcap with your hand and slide it up to reveal the white DU Bushing.
  3. You’ll see negative numbers with corresponding notches machined into the post (each # represents decreasing travel.
  4. Slide the DU bushing up and rotate it to align the black arrow with the amount of travel you would like to reduce, then seat the arrow into the machined groove. (Make sure it’s fit securely into these notches!)
  5. After pushing the DU Bushing back down, lower the midcap and hand tighten (no need to go overboard!) and ride off into the sunset with the perfect travel for you.

How Does Travel Adjust work?

Our travel adjust system allows for a total of 30mm travel reduction in 5mm increments. If you were riding that line between travel sizes you can now fine-tune the perfect fit by following the easy directions below:

  1. Begin by lowering your dropper at or below the desired travel length (just make sure it’s not fully extended!)
  2. Unthread the midcap with your hand and slide it up to reveal the white DU Bushing.
  3. You’ll see negative numbers with corresponding notches machined into the post (each # represents decreasing travel.
  4. Slide the DU bushing up and rotate it to align the black arrow with the amount of travel you would like to reduce, then seat the arrow into the machined groove. (Make sure it’s fit securely into these notches!)
  5. After pushing the DU Bushing back down, lower the midcap and hand tighten (no need to go overboard!) and ride off into the sunset with the perfect travel for you.

Specs

Details

These adapters make your Loam Lever direct mount compatible to Shimano I-Spec II, Shimano I-Spec EV or Sram MatchMaker X (MMX) brake lever clamps. Keep in mind that the 22.2mm band clamp will give you the best range of adjustment of all the clamps, but if you're wanting that tidy looking cockpit set up and willing to sacrifice a bit of adjustment, these are for you.

compatibility

Sram Matchmaker X (MMX) is for Code/Guide/Level brakes, excluding Level T

Shimano ISpec II is for XTR M9000, XT M8000, SLX M7000, DEORE M6000 brakes

Shimano I-SPEC EV (XTR M9100/M9120, XT M8100/M8120, SLX M7100/M7120, Deore M6100/M6120)

Warranty

PNW Lifetime Warranty

Do we have your back? Of course. If anything goes wrong, we're here to do everything we can to ensure you're taken care of.