Manuals

PiNE

Find your specific lever and dropper combo below and click to download your manual or scroll down to watch a digital installation guide.

DOWNLOADS

MANUAL

PINE +
LOAM LEVER

manual

PINE +
puget 1X lever

MANUAL

pine +
PUGET 2X LEVER

manual

PINE +
DROP BAR LEVER

manual

pine W/ NO LEVER

This manual is for customers who purchased the Pine without a PNW Lever, if you did purchase your post with a lever find the appropriate manual above... we promise it will make things easier!

Download

ViDEOS

pine + loam LEVER INSTALL guide


pine + 1X PUGET LEVER INSTALL guide

PINE + 2x puget lever install guide

INSTALLATION FAQ

How often do I need to service my post?

Is your post sticky, slowing down, or generally less peppy than it used to be? Then, it's likely time for a little TLC and to give it a service. Scroll to the end of this page for a video on how to service your dropper. If it's not sticky or slowing down, just go ride!

How do I adjust the return speed?

Snug up that cable tension. Make sure your housing and internal cables are lubed and not kinked or frayed!

Post sagging or dropping w/ out actuating the lever?

Check this setting first: If your cable tension is too tight, it can activate the post without you touching the lever. Try backing off of the cable tension a bit. If that doesn't do it, test the post without the cable attached to rule out a tension issue.

Can I spin the actuator collar?

Do not attempt to spin the actuator collar on any of the externally routed posts. The collar is in a fixed position, as there is an internal nylon cable that runs throughout the post. This will break if the collar gets spun, and the post will not operate properly.

SERVICING YOUR POST

PINE 27.2 SERVICE GUIDE